TOUR À BOIS 1216 LAGUNA 110 VOLTS

Brand:
LAGUNA

Descriptions:
The definitive midi-lathe, Laguna's REVO 12|16 encapsulates the prestige of Laguna in a small package. Featuring a Pulse Width Modulation system motor to maintain consistent torque at any speed, one step cam-action belt change with magnetic door housing, and a luxury banjo w/45º chamfered edge.

Features:
The 1216 controls the 1hp DC motor using pulse width modulation. A big problem with DC motor control is torque in the low speeds, and you will find many MIDI lathes with the lowest speed of 250RPM and higher because of this. This is because the cost effect controllers introduce resistance into the voltage to limit the power, which reduces the speed but also reduces the torque at the same rate. PWM will deliver full torque across the entire speed range. This allows for tremendous torque in low speeds which is helpful when roughing and precision work. This also allows for outboard turning up to a 16" bowl on a mid-sized lathe.
1 HP DC Permanent Magnet Motor.
Pulse Width Modulation (PWM) Controller.

Specifications:
Electrical Requirements: 100V-1ph-60Hz
Recommended Breaker Size: 110V - 15 Amp
Speed Range High: 650 - 3500 RPM
Speed Range Mid: 325 - 1750 RPM
Speed Range Low: 50 - 525 RPM
Distance Between Centers: 15.5 in.
Swing Over Bed: 12-1/2 in.
Swing Over Banjo: 9-1/2 in.
Max Outboard Swing: 16 in.
Spindle Bore: 3/8 in.
Spindle Taper: 1 in. x 8 TPI (Both Ends)
Front Bearing: 60006LLU
Rear Bearing: 6005LLU
Indexing: 24 Positions with Lock
Drive Belt: Poly-V Belt 6 Grooves
Tail Stock Quill Travel: 2-1/2 in.
Tail Stock Taper: MT2
Bed Length: 29.4 in.
Tool Rest Length: 6 in.
Tool Rest Post Diameter: 1 in.
Faceplate Diameter: 3 in.
Certification: CSA C/US 256540
Floor To Bed Height: 6.7 No Pads
Floor To Spindle Center: 13 in. No Pads
Overall Size (L x W X H): 35.8 in. x 14.6 in. x 20.5 in.
Net Weight: 118 lbs
Shipping Weight: 125 lbs
Shipping Dimensions: 37 in. x 15 in. x 21 in.

Included:
(1) PLAREVO1216-1103A Center Ejection Rod: Used to eject centers from the headstock.
(1) PLAREVO1216-104A Faceplate: 3-inch faceplate used to secure the workpiece.
(1) PLAREVO1836-1136 Faceplate Wrench: Used to remove the faceplate from the spindle threading.
(1) PLAREVO1836-124A Drive Center: Used in the headstock to turn a workpiece. Does not have bearings.
(1) PLAREVO1216-168 Live Center: Used in the tailstock to support the rotating workpiece. Contains bearings.
(4) PLAREVO1216-199 Rubber Feet: Rubber feet to minimize vibrations – must be removed when using a stand.
(4) Screws for Rubber Feet: PLAREVO12161100
(4) Flat Washers: PLAREVO1216198